Picture may vary.

HV-CONNEX Cable Connectors, Size 7, up to 300 kV, according to IEC 62067:2011


  • Pluggable separable connector for all XLPE cables


  • The separable connector is installed without any gas- and oilwork at the transformer or GIS
  • Considerably reduced installation time and safe installation
  • Horizontal, vertical and angeled versions for connection to GIS and tranformers
  • Rapid separation and change of cable and equipment possible
  • Touchproof, submersible, and maintenance-free
  • Routine-tested from factory

*) depending on conductor cross section and conductor material

Technical Data

Article no. 877 999 999 xxxxx
Max. system voltage Um (kV) 300
Size 7
Type designation dry-type termination
Applicable standards IEC 62067:2011
Working place outdoor and indoor
offshore on request
Nominal voltage Un (kV) 275 - 287
Conductor residual voltage U0 (kV) 160
Rated power frequency withstand voltage 1 min (kV) 320
Rated lightning impulse withstand voltage BIL (kV) 1050
Heating cycles (kV) 320
Partial discharge test < 5pc at (kV) 240
Rated power frequency withstand voltage 30 min (kV) 400
Nominal current*) IN (A) 4000
Rated short-time withstand current (kA) 63
Rated impulse current CALCULATED (kA) 170
Conductor material copper or aluminium
Diameter of conductor Ø (mm) 27.3 - 72.5
Conductor cross section area (mm2) 630 - 3000
Diameter of insulating (mm) 76.5 - 131
Connection method Compression connection


Data sheet as pdf-file
Drawing as pdf-file
CONNEX Order Form


Your request